Rear Eng Dragster

Pictured with 36" Wing.
Car Weight Race Ready with Big Block Chevy only 1520 lbs.

Rear Engine Dragster Base Car Includes:

225” Wheel Base Rear Engine Dragster (Built to NHRA Rulebook Specs.)
All 4130 Chromoly Tubing Tig Welded
Custom Fit to Driver
9” Ford Mark Williams Modular Alum Econo/Comp Housing
    Will Accommodate up to a 17x33 with 3.5 backspacing
Complete Steering
   SPE Steering Wheel (choice of grip color)
   M/W Steering Wheel Quick Disconnect (SFI Approved)
   Steering Shaft with Safety Stop
   SPE Rack & Pinion
   SPE Spindles & Kingpins
   Tie Rods with all Hardware
Tripod Front End
Wilwood Composite Brake Pedal
Wilwood Master Cylinder
Accelerator Pedal with Safety Pull-Up and Adjustable Stop
Parachute Mount/Anchor/Release Handle
Cable Mounts for Throttle/Shifter/Parachute
Shifter Mounts
Fuel Pump/Filter Brackets (Customized to your Application)
Helmet Hook on Cage
Entry and Exit Handles on Cage
Full Body: Nose to Rear Housing (Fiberglass Nose, Aluminum body)
Ground Effects Lower Body Lip
Rear End Anti-Rotation, Upper and Lower
Battery Mount and Hold Down
JAZ 4 Gal Fuel Cell
Fuel Cell Mount and Tray
Tow Hooks
Lexan Windshield
Complete Front Floor Pan
Full Aluminum Interior and Seat
Front and Rear, .250 Aluminum Motor Plates
Rear Motor Mounts
Saddle Type Front Motor Mounts with Clamps (Includes aircraft type clamps)
Driver Shield- Rear .125 Aluminum
Electronics Mounting Panel
Dash Panel (Choice of Design/Gauge/Switch layout or Customized)
Engine Movement Limiting Brace
Tail Light Mount and Tail Light
Master Cutoff Mount and Master Cutoff

$6,500.00

Add On’s:

36 to 44" Rear Wing mounted with Stream Line Struts
with your choice of Spill Plates. Add $900.00

Dragster Brake Line Kit and to Slot Chassis Frame Rail,
Reinforce it and run the Brake Line. Also includes steel
braided high pressure hose and all fittings to complete brake system Add $175.00

Other Options Also Available

Prices are subject to change without notice.